SikaBond-130 Design Floor – Flooring Adhesive

SikaBond-130 Design Floor

One-component, solvent-free, fiber-reinforced dispersion adhesive for full-surface bonding of design and floor coverings on absorbent indoor substrates. The following description summarizes the most important manufacturer specifications for selection and application by SIKA in a practical manner.

Advantages

• Easy to spread
• Hard-elastic adhesive film
• Low consumption and high yield
• Fiber-reinforced
• High initial tack and very high final strength
• Plasticizer-resistant
• Suitable for wet-bed bonding
• Suitable for underfloor heating
• Suitable for chair casters according to DIN EN 12529
• Suitable for shampooing according to RAL 991 A2

Areas of application

• Vinyl design flooring (LVT)
• PVC and CV flooring
• Textile flooring with PVC or fleece backing
• Insulating underlays
• Single- and multi-layer needle-felt flooring

Technical data

• Chemical basis: Dispersion adhesive
• Density: approx. 1.25 kg/l
• Packaging: 14 kg plastic bucket
• Color: Light beige
• Shelf life: 12 months
• Air temperature during application: +18 °C to +35 °C
• Relative humidity: 40–65 %
• Curing approx. 24 h; final strength approx. 72 h
• Open time approx. 20–30 min; working time approx. 5–20 min
• Typical consumption depending on flooring/embossing approx. 250–450 g/m²

Certifications & Tests

• EMICODE EC1PLUS
• Emission-tested building product according to DIBt principles

Application & Substrate

• The substrate must be clean, dry, level, dust- and grease-free, and ready for flooring according to DIN 18365.
• Prepare non-ready substrates with suitable mechanical or priming measures.
• Additionally observe the flooring manufacturer's specifications for moisture, substrate, and application.

Notes / possible disadvantages

• Intended only for absorbent indoor substrates.
• Open time and working time react to the site climate; applying too early or too late can impair the bonding.
• The residual moisture of the screed must be within the limits specified by SIKA.

FAQ

Which variant is suitable?
Color and packaging are selected separately. For packaged goods, individual units, half pallets, and full pallets are available, where applicable.

Does it need to be primed?
This depends on SikaBond-130 Design Floor, the substrate, and the load. The above notes and the current SIKA product data sheet are decisive.

Can I use the product outdoors?
Only to the extent that the respective application is approved by SIKA for outdoor use. The substrate, moisture, temperature, and load are decisive.

What is important for storage and application?
Store containers closed, dry, and within the temperature limits specified by the manufacturer. Observe the product and safety data sheet before application.

Brand notice

SIKA®, Sikaflex®, SikaBond®, Sikacryl®, Sikafloor®, Sikagard® and Sikasil® are trademarks of the Sika Group. Technical specifications refer to the SIKA product information available at the time of creation; in case of doubt, the current product data sheet of the manufacturer applies.